Forum Post: RE: AM5716: QSPI boot issue
Hi, the steps you wrote do use the "sf" commands, there is nothing wrong with it. And I have no issues using "sf" to read/write flash, and ROM loader to boot from it. The question was: even if U-Boot...
View ArticleForum Post: RE: 66AK2H12: EDMA speed performance decrease due to SRIO
Hi Eric, Sorry, I am asking customer and waiting their response.
View ArticleForum Post: RE: RTOS/AMIC110: Mismatch between CoE EtherCAT and input data
Hi Giulio, we documented some steps on how to change/add PDO in our PRU-ICSS EtherCAT slave troubleshooting guide . You mentioned you uses SSC tool, the document shows steps for manually doing this...
View ArticleForum Post: RE: PCIe interrupt set in RC-mode
Hi. Thank you for your answer. I'll check your answers. I was testing without an EP by setting up RC-mode with evmc6678. It was a test to confirm whether the ISR was executed. During the data survey, I...
View ArticleForum Post: RE: Linux/PROCESSOR-SDK-AM335X: Ethernet boot on custom board
Thanks Krunal, We did a small mistake. We've to connect eth0 interface of the board with the host system. but we connected eth1 port and did the procedure. Now we are trying with eth0 and I'll let you...
View ArticleForum Post: RE: TDA2SX: Connecting DS90UB934 to TDA2SX
TDA2x VIP can capture 10-bit data by setting the VIP in 16-bit mode. Whether to capture 10-bit or 8-bit depends on if you want to process 10-bit data or not. If you want to process 10-bit, no need of...
View ArticleForum Post: RE: TDA2SX: What IDE is recommended to customize the Vision SDK?
Hi Zach, I am not an expert on Radar SDK. I would suggest you to post a separate question for your query about source code. Regards, Rishabh
View ArticleForum Post: RE: Linux/AM3358: 4G USB Simcom module IC detect issue
we soldered 5v line to VBUS of TPD4S012 ic
View ArticleForum Post: RE: Linux/AM3358: Custom board boot issue
Hello Aleksandar, Thank you for sharing the solution. Cold you also mark the solution as "This resolved my Issue". Thanks, Kemal
View ArticleForum Post: RE: Linux: eMMC cannot boot on MMC0 am335x
Hello Mouri89, You need to modify the loadimage U-Boot environment variable. Please, see this thread for more details. Note: If you put the SD card (4GB) on MMC0, eMMC 16GB on MMC1 and use the latest...
View ArticleForum Post: RE: Linux/AM5718: PRU Ethernet does not work
Hi Nick, I have configured the reset-gpios for pruss2_mdio but still the PRU-Ethernet won't work. So could you update us about the RXLINK for conclude this issue. Regards, suresh
View ArticleForum Post: RE: 66AK2H14: 1 GBE 5 Port Ethernet Switch is not designed to...
Hi, In pdk_k2hk_4_0_12 Example folder There is an NIMU_emacExample that use NDK . I can not use NDK because I have to use multiple core to transmit data through Ethernet port. I also use...
View ArticleForum Post: RE: RTOS/TDA2PXEVM: High display latency in...
Hi Andrey, The display where it shows 90ms latency is not really running, the fps reported is all 0s. I think the first display is where iss output is connected and the latency in that is around 14ms.....
View ArticleForum Post: RE: Linux: eMMC cannot boot on MMC0 am335x
Hi Kemal R. Shakir , Thanks so much for your help, i had done your guideline, it cannot not boot. I think my uboot source code base beagle bone black, it has some pin in MMC0 to network device. I will...
View ArticleForum Post: Linux/AM5718: Single EMAC configuration
Part Number: AM5718 Tool/software: Linux Hi, I had trouble in changing the dual emac model into the one,as Our project has redesigned the baseboard. I had change the dtb,as i had did these things or...
View ArticleForum Post: RE: ISS_CAPTURE failure in Radar SDK
Hi Saito-san, If they have connected it PHY 0 of CSI2 and assuming virtual channel is 0, please check contents of 0x489B 0354, this should increment. If the virtual channel is different please check...
View ArticleForum Post: RE: RTOS/TDA2HV: patch of A15 SMP NDK based on Vision SDK 2.09
Hi, I am not sure if the NDK has any dependency based on SMP is enabled on bios or not. I can check with the NDK team and get back to you. As of now I don't think there is a patch available. Your issue...
View ArticleForum Post: RE: RTOS/TDA2HV: patch of A15 SMP NDK based on Vision SDK 2.09
hi Anand, i am trying to send packets, but will be blocking after several calling "send" API
View ArticleForum Post: Linux/AM5718: DP83822 interface to GMAC SW0 AM5718
Part Number: AM5718 Tool/software: Linux Hi, I have taken a deviation from EVM by choosing DP83822I Ethernet PHY for a custom board. EVM uses KSZ9031 (RGMII) PHY , interfaced to CPSW. My requirement is...
View ArticleForum Post: AM5728: OCMC RAM cache enable
Part Number: AM5728 Hi, I want to enable cache of the OCMC RAMs (DSP side). But according to the CorePac (sprugw0c) document, the OCMC RAMs region are in the shaded portion in the table that indicates...
View Article