Quantcast
Channel: Processors
↧

Forum Post: RE: AM62A7: AM67A74 & AM62A74

I suggest you look at the sysconfig tool. You can find the online version at https://dev.ti.com/ (an account is required) or you can download from https://www.ti.com/tool/SYSCONFIG Select the desired...

View Article


Forum Post: CCSTUDIO: whether complier support C++

Part Number: CCSTUDIO Tool/software: C2000 Complier report error for complex.h file as below, customer would like confirm if complier support C++? Any setting need to operation on CCS to enable C++?

View Article


Forum Post: RE: SK-AM62A-LP: Board is not booting up with tisdk build

Hello, In that case, can you check the md5sum of the U-Boot images in both the cases. Ideally, they should be same. However, if they differ then we know there is some issue. Specifically, Flash the SD...

View Article

Forum Post: RE: AM62A7: Methods and tools for quickly batch programming eMMC

[quote userid="651585" url="~/support/processors-group/processors/f/processors-forum/1506485/am62a7-methods-and-tools-for-quickly-batch-programming-emmc/5794715#5794715"]How should I set the value for...

View Article

Forum Post: RE: SK-AM62P-LP: How enable raspberry PI panel on am62p evk

Hello, Please point me to the other thread where you saw this panel discussed. We can support questions about TI hardware and TI software on these forums. However, we cannot answer questions about...

View Article


Forum Post: RE: SK-TDA4VM: Issue Flashing Yocto Image to SD Card for SK-TDA4VM

Hi Naveen, Can you try a different SD card? Perhaps a 16 GB SanDisk card. That is what I tested with recently. Best, Jared

View Article

Forum Post: RE: TDA4VH-Q1: Artifacts built with 10.1 version do not work.

Hi Alex, could you share your calibration dataset? Dev team is going double check with it, but may need some time since they are also working the 11.0 release. Warm Regards, Christina

View Article

Forum Post: CCSTUDIO: v20 - Automatically clear the "problems" window on a...

Part Number: CCSTUDIO Tool/software: Is there a way to automatically clear the "Problems" window on a build? It can be confusing when a line in source is marked as a problem, but it has been fixed.

View Article


Forum Post: RE: AM3359: EtherCAT: Busy bit not reset when reading SII

I'll have to check on this. Give me sometime while I check on this and get back to you. Thanks, Aaron, I appreciate that. Knowing when the busy bit is set might help us locate the delay between there...

View Article


Forum Post: RE: TDA4VH-Q1: Artifacts built with 10.1 version do not work.

Hi Christina, Please find attached. e2e.ti.com/.../calibration_5F00_dataset.tar.gz Thank you, Alex.

View Article

Forum Post: RE: AM62L-PROCESSOR-SDK: AM62L UART 9-bit addressing mode

Hi GR, The TRM Table 12-122 explains the IrDA mode. Linux or FreeRTOS only supports UART mode, but not IrDA or CIR mode.

View Article

Forum Post: RE: TDA4VH-Q1: Multicamera streaming Issue

Hi Rithika, Could you try it with SDK version 10.0? Thank you, Fabiana

View Article

Forum Post: RE: AM625SIP: Trying to boot from eth device

2. I see the same behavior when using SDK 11 for eth boot. --Marcin

View Article


Forum Post: RE: AM62L: AM62L SD Card Boot Compatibility Issue

Yes, this is a known issue, errata is in the process of being updated. Your observations align with ours, in that several different types of SanDisk cards fail, while cards from other manufacturers...

View Article

Forum Post: RE: CCSTUDIO: v20 - Automatically clear the "problems" window on...

Hi Lori, It should be cleared on a project build. However there is this known issue: https://sir.ext.ti.com/jira/browse/EXT_EP-12041 Is this what you are running into? Note the part about the header...

View Article


Forum Post: RE: TDA4VH-Q1: Artifacts built with 10.1 version do not work.

Thank you Alex. I have added it to the Jira. Warm regards, Christina

View Article

Forum Post: RE: DRA821U: Failed to connect J7200 EVM with Blackhawk USB560v2...

Okay, can you tell us why you're not using the onboard XDS110 interface? Also, how are you connecting your USB560v2 to the J7200 EVM? We generally use the onboard XDS110 interface. Based on your above...

View Article


Forum Post: RE: TDA4AEN-Q1: App for Wake-up Domain

Hi Vishal, HSM will be a separate binary, so it will not be part of app or tiboot3.bin . Thanks, Neehar

View Article

Forum Post: AM625SIP: Need for heatsink?

Part Number: AM625SIP Tool/software: I've searched E2E and bit and haven't found a good answer on this topic yet. Can you please point me to some resources on how to estimate whether or not a heatsink...

View Article

Forum Post: RE: AM62A7-Q1: Accessing MCU GPIOs and SPI from Main Domain R5F...

Hello Fatma Amr Thank you. From the processor capability this should be possible but may have software dependencies. Let me check internally and reassign. Regards, Sreenivasa

View Article


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>