HI Miroslav,
Hope you’ve already checked the power and clock signal .Then place the device in the emulation mode and try connecting the board to the CCS via JTAG to make sure you are establishing the connection and try running some statreware example LED Blink,UART test,memory tets ....etc.
Running Linux Application
For running Linux application the first step is to select which bootable device you’re going to use to boot the board once you select it then second step is to customize, build and flash the U-boot on the target hardware according to your board configuration (memory size) etc. And third step is to build and flash kernel into your target hardware and run some sample application on top of it.
TI provides the Sitara Linux software developer’s guide that explains to you the steps involved in creating and flash the U-boot and kernel image in the target hardware.
http://processors.wiki.ti.com/index.php/Sitara_Linux_Software_Developer%E2%80%99s_Guide
Regards
Antony
- --------------------------------------------------------------------------------------------------------
Please click theVerify Answerbutton on this post if it answers your question.
--------------------------------------------------------------------------------------------------------