Hi,
I would like to use emulator XDS200 to debug a small project. I do not understand which boot mode I should use, see below table. Could you explain it to me? Thanks,
Switches (SW1)
Switches 1-4 on SW1 are used to set the BOOT as follows:
| Switch # | UART2 | NAND 16 | MMC/SD0 |
|---|---|---|---|
| 1 | OFF | OFF | OFF |
| 2 | ON | ON | OFF |
| 3 | OFF | ON | OFF |
| 4 | ON | ON | ON |
