Hi ,
I am facing problem problem in booting custom board based which is made keeping Appro DM365 IPNC board as referance.
I have changed UBL for DM365 IPNC board(as Appro board used UART1 and custom board has UART0 as debug port). And it seems UBL is booting fine but it gets stuck at the end and u-boot doesnt boot,
here is a log for the same
DM36x initialization passed!
TI UBL Base Version: 1.50
Boot Loader BootMode = NAND
Starting NAND Copy...
Valid magicnum, 0xA1ACED66, found in block 0x00000020.
DBG:Nandboot:Gentrypoint:0x81080000Boot Mode Task Completed
IPNC UBL Version: 2.2.0
Platform: DM365-297
Reset RTC Fail..
UBL Executed Sucessfully
Jumping to entry point at 0x81080000 --> Hangs hereCan someone please suggest where should i look to solve this error ?
What might cause u-boot to not boot afer UBL ?
Should i look into u-boot code or UBL code for the same ? Which part of the code ?
Thank you,
Regards,
Ankur