Hi,
thanks for your Quick reply.
we are using UCD74120 part in my project.we are configuring the UCD9222 to UCD74120 bcos we have two DSP processor on my board.Is this configuration is fine?.Pls confirm.
can you help.For avoiding the in-rush current in my board.i want delay the UCD74120 switching on between the multiple UCD74120 chips.
UCD9222 have enable signal.this enable signals are giving control to system supervisor.But in datasheet not mentioned anything how to delay the enable signal.This enable signals we can control through the I2C bus,
We have checked the TMDSEVM6678Lx_EVM_REV_3_0 schmeatic.in power sequence it showing enables are high at a time.
Regards,
srinivasarao.