Forum Post: RE: 6678 I2C EEPROM programming procedure for new / custom board

Rahul-

Thanks for this guidance, these are helpful.

Currently I'm in a customer location and there is time pressure to test I2C boot.  What I need to know is where in the .bin file, after it's loaded to memory at 0x0C000000, is the DDR3 configuration table?

We are loading eeprom50.bin, the same file as used for the EVM 6678.  I only need to change the parameters having to do with memory organization (number of banks) since this part of our board is different than the EVM.

Once I have the offset from 0x0C000000 I can change the parameters as needed, write the I2C EEPROM, and verify boot with DDR3 initialization.

Thanks.

-Jeff