Hi,
I was trying to understand boot sequence for srio switch(cps1432), and i need some help. May be this question is simple but i did not understand. At 1st stage cps1432 switch initialization sequence ie I2C initialization, in EEPROM some registers and their values should be placed a/c to eeprom format and the cps1432 will read that configuration and configure itself and then go to next stage. so my question is what are the powerup configuration for cps1432 need to set before software initializaion should start? what are the registers need to be updated before going to next stage?
I asked here because i found cps1432 related stuff here. I am a kind of new to RapidIO technology so pls help. If i am missing something then please point it out.
With Regards
Ashish