Jamse,
I am not sure about other TI employees, or other Community Members, but it is very difficult to debug someone's code for a custom board. The only method that seems to work well for me on the forum is for you to give describe some of the major aspects of the design and how you are writing the software; not a huge amount of information but enough so someone can help you. I was at a loss reading this to know where to start.
Since your new thread How to test the bandwidth(transmit rate) of the srio message? demonstrates that you have messages going across SRIO now, can you briefly tell us here what your solution was? This will help the Community who will then know more and be able to help you better next time.
Regards,
RandyP